The appearance of food waste processor makes our awareness of the convenience of life, it is a kind of electric appliances, motor drive the flywheel, the flywheel is connected with the impeller loose. The rotating impeller impinged on and cut cut purify indoor food waste, until they run into tiny particles, in order to follow the drainage pipelines will be rushed to the sewage treatment system.

Garbage processor usually include maintenance flywheel, hoses and seals, and the wear of impeller.

Repair the flywheel: in the garbage processor, flywheel rotating will drive the impeller, and then chopped food waste. If the flywheel can not rotate, the garbage processor will lose its effect. In addition, if the flywheel stuck too long, is also likely to burn off the motor. Fortunately, the flywheel is generally easy to loose. Here is the method of loose flywheel:

Step 1: check whether the bottom of the garbage processor has a hexagonal hole.

Step 2: if you have, please find near the garbage processor bag or its a hexagon wrench. Use the hex wrench can rotating shaft of the motor and the flywheel, without having to open garbage processor. If not found the wrench, please check your toolbox or buy a hand.

Step 3: just put the hex wrench inserted into the holes in the hexagonal, then turn right or left, and to loose the flywheel.

If there is no hexagonal holes, can insert a short length of drain holes of the broom, and its end on the floor beside the impeller. Applying pressure to leverage gradually, make the impeller according to a direction, to loose flywheel.

Repair hoses and seals: people often complain about garbage disposal opportunity will be water leakage into the cabinet below. Through the study of water leakage and the location, general can determine its source.

If the water had food stains, then drain or dishwasher inlet is leaking. If the water has been relatively warm, then it probably comes from a dishwasher. If the water is clear, may be not into garbage processor of the water tank.

Step 1: put the hand on different positions of the processor. Sometimes you can feel the water flows through a palm and leakage location can be determined.

Step 2: if the leakage appear below the garbage processor, may be water seepage in the motor through the flywheel the seals. In this case, you need to remove the garbage processor from the drainage system. Then, open the device, and then replace the seal. You can hand it over to the professional maintenance repair shop.

Repair the wear of impeller:

Step 1: remove the garbage processor power. Remember should first disconnect cut-off machine, if the garbage processor directly to indoor, you need to disconnect the main junction box of the fuse.

Step 2: remove the garbage processor all the in and out of the hose fittings. At this time, some garbage processor can be out of the ring gasket under rotation, which is then discharged. While others need to twist the screw on the ring gasket. Please remember, garbage processor wants relatively heavier in the small home appliance, therefore remove the garbage processor will make its weight all in your hands.

Step 3: in many models, the need to remove the flywheel when repair the wear of impeller. Can use a screwdriver to hold the flywheel, then loosen lock nut flywheel.

Step 4: remove the flywheel, can remove the impeller and the in situ polishing. If unable to grinding wheel, the flywheel component needs to be replaced.